Lazertran Transfer Paper Before You Begin Make sure you are using the correct type of Lazertran product for your printing device. Using the wrong Lazertran in the wrong machine can cause damage to your machine. Preparation: Lazertran Transfer Paper Step One Inkjet print images on to the Lazertan Inkjet paper. Step Two Cut out your images as close to the edge of the artwork as possible. Step Three Place Lazertran into a container of water face down. Lazertran is ready when the backing starts to slide away from the image. This usually takes 1-2 minutes. Step Four Gently blot excess water off the Lazertran using paper towel. Non-Absorbent Surfaces: Transfer onto Metal Step One For non-absorbent shiny surfaces, no glue other than the gum on the back of the transfer is required. Place Lazertran on the surface and slide the back from under the image. Smooth out the surface carefully to remove any air bubbles. Leave to dry. Difficult Surfaces: Transfer onto Paper, Wood, Wax, Stone, Plaster & PVC Option A: Binder Medium Step One Apply Atelier Binder Medium to seal the surface. Step Two Place Lazertran on the surface and slide the back from under the image. Allow to dry. NB: Lazertran can be sealed with an acrylic gloss – however this is not required. Option B: Pure Gum Turpentine Step One Apply Pure Gum Turpentine generously to the surface. Step Two Place Lazertran on the surface and slide the back from under the image. Step Three Dab Pure Gum Turpentine gently over the image, making sure not to brush the artwork as it will bleed. Step Four Leave to dry.